When the wall bracket cannot meet the requirements of the construction site it should be designed and calculated separately.Setting requirements: The installation and dismantling workers, electricians, and other operators of construction electric elevators should have special construction operations.Saint Denis,PoleSetting requirements: The verticality deviation of the installation of the guide rail frame of the construction electric elevator should comply with the requirements of the user manual and specifications, as specified in the above table.Kota Baru,Setting requirements: The guide rail should be rigid and flexible components such as wire ropes or chains should not be used.To meet the needs of stage craftsmanship and layout; Product; In the music and dance theater stage arranged in a zigzag pattern, auxiliary lifting platforms are often arranged in front, back, left and right of the main stage lifting platform. The side and rear auxiliary lifting platforms are used for the smooth opening of the side platform and rear vehicle turntable, while the front auxiliary lifting platform is used to place the rear vehicle turntable near the platform entrance. The leveling and lifting platform below the side platform and rear vehicle turntable can be used to level the platform after the side platform or rear vehicle turntable is driven out, so that the entire platform does not have a height difference, ensuring the safety of the cast members.The end height of the guide rail frame above the high attachment point should comply with the provisions of the user manual.

Every theater is a public place with a large number of people, in order to prevent accidents caused by the crushing of electric elevators or improper control by drivers. Electric elevators should be equipped with the following necessary safety devices to ensure that the car of the electric elevator stops rising or falling in a timely manner.Limit switches should be triggered directly by the movement of the suspension cage or its related components.The bearing capacity of the building structure at the attachment point of the wall bracket should meet the requirements specified in the user manual for construction electric elevators.superior quality,Saint Denisozone layer,There is no need to set up a computer room above the shaft like an elevator, and the top floor height can be installed at least . meters.The bearing capacity of the ground under the concrete foundation plate should be greater than .Mpa.Safety grounding device. In order to protect against electrical equipment. The metal casing of electrical equipment and the metal structure of electric elevators should be equipped with a safety grounding device. The grounding wire should operate multiple wires,Saint DenisTuramor,Saint DenisQingshan City, and the neutral wire should not be arbitrarily held as a safety grounding wire. Its grounding resistance should not exceed ohms; The power supply of the electric elevator can be cut off.

Acceptance: Concrete strength grade C, strength testing report.Product survey,When the wall bracket adopts non matching standard products, design calculations should be carried out.After the limit switch is activated, only professional personnel can restore the movement of the suspension cage; Limit switches and travel switches should not share the same triggering element; Limit switches should be either suspended orThe verticality of the guide rail frame should meet the requirements of the specifications.Saint Denis,With the continuous improvement of urbanization level in China, the number of high-rise buildings in urban areas has sharply increased, and the height of buildings has also continued to grow. This has created a demand for high-altitude lifting platform vehicles. Therefore, in order to meet the needs of the domestic market and the public, efforts will inevitably be made to design and produce high-altitude lifting platform vehicles.Horizontal lead screw mechanical electricityOperating cost advantage and low failure rate: Due to the use of advanced hydraulic systems and good methods